Contact Us
Attn: Roger
Tel: +86-510-80228229 / 83759637
Mob: +86-13585004869
E-mail: sales@wxbaoda.com.cn
Address: No.18-1, Zhanghong Road, Xizhang Industry Park, Wuxi, Jiangsu, China.
Home > Knowledge > Content
Inspection requirements for HDPE multi-angle welding machines
Aug 08, 2018

The HDPE multi-angle welding machine effectively includes the operation table in the process of operation, the surface of the operation table is provided with a controller, and the column at the top center of the equipment operation table is provided with a column, and the top of the column is provided with a clamping member.

The top of the operation table is further provided with a sliding slot, the sliding slot is located outside the column, and the annular wall is provided at four corners of the inner wall of the sliding slot, and the surface of the annular beam sleeve is provided with an annular opening, and the inner cavity of the operating table is provided a storage compartment, and the storage compartment is located at one side of the chute, and two compartment clamps are arranged in the storage compartment, wherein the side of one of the clamps is connected to the output shaft of the motor fixed on the wall of the storage compartment, and the clamp connected to the motor A steel cable is connected, and the other end of the cable runs through the annular bundle and is connected to the other line.

Advantages of using HDPE multi-angle welding machine

1. HDPE multi-angle welding machine can directly reduce the heat to the minimum required. The metallographic range of the heat-affected zone is small and the deformation caused by heat conduction is also the lowest.

2. The welding process parameters of the HDPE multi-angle welding machine are effectively tested, which can reduce the time required for the thick plate welding and even eliminate the use of filler metal.

3. HDPE multi-angle welding machine does not need to use electrodes, there is no concern about electrode contamination or damage. And because it is not a contact welding process, the wear and deformation of the machine can be minimized.

http://www.wuxibaodamachine.com/


Previous: HDPE pipe special shaped pipe welding machine requirements

Next: Operation process of All Terrain Butt Fusion Machine